Final Adjustments - golmar V2PLUS Manuel D'installation

DOOR PANEL INSTALLATION
L
amps wiring .
Once the nameplate labels are placed, wire the lamps from
different modules and connect them to terminals L1 and L2 of
the sound module
If the number of door panel lamps is higher than six, c
TF-104 transformer between the ~1 and ~2 terminals of the
sound module and change the JP2 jumper position
NOTE: Don't change JP1 jumper position JP1 and JP2 jumpers are placed on the left side of the
sound module terminal connection block
lock release is also used, wire ~1/~2 terminals of the sound module with CV1/CV2 terminals
respectively of the EL-500/V2Plus.
F
inal adjustments
Sound Module:
If after starting the system it's considered that the audio
volume isn't correct, proceed with the necessary
adjustments as shown
The telecamera has a pan and tilt mechanism If the
orientation is not adequate then correct its position
In case of low light conditions, an external illumination can be
activated by connecting a SAR-12/24 relay between the
'+H' and 'L2' terminals of the sound module
IMPORTANT: The power to the SAR-12/24 relay must not exceed
1,8A to 30Vdc/250 Vac
See document TSAR-12/24 for its connection and characteristics.
Microprocessor Circuit:
The EL500/V2PLUS microprocessor circuit has a
potentiometer "PT1" to remove the possible audio
feedback in the installation The potentiometer can be
accessed via a hole, making it unnecessary to remove the
circuit protection cover Make the adjustment as shown in
the picture .
IMPORTANT: If feedback persists after having adjusted the
potentiometer "PT1", then consult the "troubleshooting hints"
section on page 119.
.
.
.
.
.
.
onnect the
.
.
. If the TF-104 transformer with alternating current
.
.
.
93