golmar V2PLUS Manuel D'installation page 88

DOOR PANEL INSTALLATION
A
ssembling the EL500/V2PLUS microprocessor circuit
and the EL516SE push buttons encoders
The EL500/V2PLUS circuit is to be assembled on the top of
the embedding box Insert the circuit in the top flanges
of the embedding box (1) Push-in the circuit in the
bottom flanges (2) by pressing the pcb board
2
1
I nsert the sound module in the grille module
.
.
.
To assemble the EL516SE encoder, screw the top tab of the
case to the corresponding plastic lug of the embedding
box Place the circuit on the inferior flanges and screw it .
into the embedding box
In case of more than one encoder, place them underneath
or in the next embedding box
The use of EL516SE encoders is only necessary for panels
with more than 8 push buttons Each encoder allows the
connection of 15 push buttons
A
ssembly the sound module
For a proper assembly, align the light push
button and the microphone rubber of the
sound module with its corresponding holes
in the grille module .
.
2
.
.
.
.
87
.
.
1