golmar V2PLUS Manuel D'installation page 103

102
P
rogramming the telephones
L ocate the configuration dip switch situated under the protection
cover of the EL500/V2PLUS microprocessor circuit and set
number 2 to ON as described on page 92
The door panel will reproduce a sound to advise that the system
has entered into programming mode
Master
double
click
nd
2 Slave
Each apartment must have one master unit only; if there is a parallel unit, be it a monitor or
telephone, it must be configured as slave.
TELEPHONES PROGRAMMING
.
.
With the door release push button pressed, pick up the
telephone's handset.
To show that the system is ready for programming, the door
panel and handset will reproduce a tone, and audio
communication can be established
The
To program the telephone as master, replace the handset
To program it as
once. After the door panel and handset reproduce a short
tone, replace the handset If a long tone is reproduced then
an error has occurred; reconfigure the telephone
st
1 Slave
To program it as
twice. After the door panel and handset reproduce two
short tones, replace the handset If a long tone is
reproduced then an error has occurred; reconfigure the
telephone
Make a call to check that the telephone has been successfully programmed
Repeat these steps to program the rest of telephones
Once the programming has finished, set the programming switch to
you don't, the door panel will reproduce a sound to advise that the system
is still into programming mode
.
door release push button can be released
Press the door panel push button that will
call to this telephone At this moment
both door panel and handset will
reproduce tones
st
1 Slave press the lock release push button
.
nd
2 Slave press the lock release push button
.
.
.
.
.
.
.
.
.
.
OFF. If
.