golmar V2PLUS Manuel D'installation page 90

DOOR PANEL INSTALLATION
P
lace the nameplate labels
T wist the call wires as shown The call wires will be
connected to the EL500/V2PLUS microprocessor
circuit or to the corresponding EL516SE push
buttons encoder
.
Open the label holder .
For a quality finish, pass the push buttons wires through the
spacer hole of the closest module It's recommended to use
wires with sections
.
.
IMPORTANT:
the several push buttons modules The common terminal
of the push buttons contained in a module are linked
from factory
This wire must be connected to the CP terminal of the
EL500/V2PLUS microprocessor module and to the
corresponding CP terminal of its EL516SE encoder
circuit
between 0,1 and
link the push buttons common terminal of
.
(if there is).
Place the label
and close .
P
ush buttons wiring
.
2
0.25mm section .
.
89
.