Disposal And Recycling - PrimAster TS2000 Traduction Des Instructions D'origine

15. Disposal and recycling

The equipment is supplied in packaging to preven it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
Old devices must not be disposed of with
household waste!
This symbol indicates that this product must
not be disposed of together with dome-
stic waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE).
This product must be disposed of at a designated
collection point. This can occur, for example, by han-
ding it in at an authorised collecting point for the re-
cycling of waste electrical and electronic equipment.
Improper handling of waste equipment may have ne-
gative consequences for the environment and hu-
man health due to potentially hazardous substances
that are often contained in electrical and electronic
equipment. By properly disposing of this product, you
are also contributing to the effective use of natu-
ral resources. You can obtain information on collec-
tion points for waste equipment from your municipal
administration, public waste disposal authority, an
authorised body for the disposal of waste electri-
cal and electronic equipment or your waste disposal
company.
16. Troubleshooting
Problem Possible Cause
Saw blade gets loose Fastening nut tightened insufficiently
after turning off the
motor
Motor does not start a) Fastening nut tightened insufficiently
b) Extension cable defect
c) Connections on the motor or switch defect
No motor output turns Overload by dull saw blade, thermoprotection
off automatically is triggered
Burns on the cutting a) Fastening nut tightened insufficiently
surface b) Wrong saw blade
c) with longitudinal cuts c) Longitudinal stop not parallel
d) with cross cuts
d) Slide carriage not parallel
26 І 40
Help
Tighten fastening nut, M20 left-handed thread
a) Check the mains fuse.
b) See "Electrical Connection" in the operating
manual
c) Have it checked by an electrician
Insert a sharpened saw blade; motor can be turned
on again after the cooling period
a) Insert a sharpened saw blade
b) Insert saw blade with 20 or 28 teeth for
longitudinal cuts
c) Exchange the longitudinal stop
Align the slide carriage with the saw blade