Tecno-gaz EUROPA B 24 Mode D'emploi page 31

PAR. 6
REPLACING PRINTER PAPER
To replace the paper roll, open the cover of the special compartment and insert a new thermal paper roll
(maximum width = 57 mm) and feed a little paper through while re-closing the cover.
At the end of each sterilisation cycle, the autoclave prints a validation report. Rip the report off the autoclave
aginst the cutting edge. After removing a report, make sure the cover is properly closed.
Thermal paper can be printed on one side only so always check it is the right way round.
To ensure long life of filed sterilisation reports, make sure they are stored well away from direct light
and heat.
If the report is faint, clean the printer head (See photo- detail A). To do so, open the paper cover and
then remove the roll to clean head with a little alcohol on a clean cloth.
A
31