Using The Remote Control; Switching On/Off; Switching On/Off With The On/Off Button; Switching On/Off With A Microphone - Bosch CAD 12 Mode D'emploi Et De Montage

42 | en
In order to leave the menu,
f press the MENU G button, repeatedly if
necessary.
Note:
When the external IR input via
chamber D is activated, the inte-
grated IR sensor O is deactivated.

Using the remote control

Point the remote control at the infrared
receiver at the front of the device (or at
the separate infrared receiver, if installed).
From its front side, the infrared receiver can
"see" an area of approximately 30° in all
directions. Hold the remote control in this area
when you press a button.
7 620 210 015/020-022 | 06.2015
Preparing the remote control for use | Switching on/off

Switching on/off

There are various ways of switching the device
on/off:
Switching on/off with the On/Off
button
f Press the On/Off button D to switch on.
f To switch the device off, press and hold
down the On/Off button D for longer
than two seconds.
Note:
To protect the vehicle battery, the
device is automatically switched off
after an adjustable time period if the
vehicle ignition is switched off (see
the section "Setting the switch-off
time" in this chapter).
Switching on/off with a micro-
phone
If a microphone is connected to the device, the
device can be switched on and off with the
microphone for making announcements. For
further details read the "Microphone mode"
section in the "Adjusting the volume" chapter.
f Switch the microphone on while the
device is switched off.
The device automatically switches on and
allows you to make announcements over the
connected loudspeakers.
f Switch off the microphone.
The device switches off again.
Robert Bosch Car Multimedia GmbH