General; Installation - HYDAC ELECTRONIC HAT 1200 Notice D'utilisation

HAT 1200 Analogue Safety

4 General

The HAT 1000 angle sensor series are subjected to individual calibration and final testing
on a computer operated test station. They are maintenance-free and operate perfectly
when used according to the specifications (see Technical Data).
However, if there is a cause for complaint, please contact HYDAC Service. Interference
by anyone other than HYDAC personnel will invalidate all warranty claims.
If you have any queries regarding technical details or the suitability of the unit for your
application, please contact our Technical Sales Department.

5 Installation

Before mounting HYDAC Angle Sensor, make sure there are no strong magnetic and
electric interference fields nearby.
Inadmissible interference fields can influence the measuring accuracy.
The measured value is transferred contactlessly to the sensor via the magnetic field of
the magnet located at the end of the drive shaft.
The measuring system can be connected to the drive shaft by means of an elastic coupling
which can absorb radial and axial deflections.
It prevents from inadmissible bearing loads.
The centering hub at the front of the sensor serves as a reference for the centering of
the shaft with regards to the drive system. The angle sensor is either connected to the
assembly plate (not supplied with the device) at the front side by means of servo clamps
or directly via bolts.
Assembly plate
coupling
Edition: 2021-02-18
3 x bolt M3
Centering hub
Ø 33 h7 x 1.6
HYDAC ELECTRONIC GMBH
3 x servo clamp
Part No.: 669956
9
E