Metabo HPT NP 18DSAL Manuel D'instructions Et De Sécurité page 22

English
(4) Remove any nails, adhesive, fragments, splinters or other foreign objects jammed in the guide groove of the push
lever or the blade guide.
Driver blade position
[Blade guide side]
Blade Guide
Clogged
Nail
Driver Blade
[Push lever side]
Push Lever
Clogged
Nail
Driver Blade
(5) Attach the guide plate and nose.
Guide Plate
Bolt (×2)
Insert the projection of the guide plate into the guide
hole and secure it with the hexagon hole bolt M5×8.
(If the projection of the guide plate is hard to insert,
tap it lightly with the handle of the screwdriver.)
22
(1) Bend the driver blade back with
the slotted screwdriver.
(2) Remove the nails with the pliers.
(3) Remove any nail fragments or dirt
that remains in the guide groove
with the slotted screwdriver.
(1) Remove the nails with the pliers.
(2) Remove any nail fragments or dirt
that remains in the guide groove
with the slotted screwdriver.
Magazine
Driver Blade
Push Lever
Nose
How to remove jammed nails
(6) After assembling, pull out the push lever and nose
and check that they move up and down smoothly.
Guide Plate
* Do not place your hand in front of the
discharge outlet when checking operation
If any jammed nails remain, movement will not be
smooth.
In this case, repeat from step (1) again.
CAUTION
● NEVER hit the driver blade.
● NEVER point the tool at yourself or another
person, to avoid risk of injury by mis-fi ring.
NOTE
In case of frequent jam, contact a metabo HPT
authorized service center.
Driver Blade
Nail
Slotted
Screwdriver
Pliers
Guide
Groove
Nail
Guide
Groove
Pliers
Nose
Push Lever