Metabo HPT NP 18DSAL Manuel D'instructions Et De Sécurité page 25

Maintenance chart
ACTION
Clean magazine.
Keep push lever working properly.
Operator troubleshooting
Most minor problems can be resolved quickly and easily using the table below.
If problems persist, contact a metabo HPT authorized service center for assistance.
PROBLEM
The pin nailer won't fi re
nails.
Nails are not fully driven in. The material is too hard.
Blank fi ring.
Prevent a jam.
Promote operator safety and effi cient
Nailer operation.
POSSIBLE CAUSE
The battery has run out of power. (The
remaining battery indicator lamp does
not light.)
The battery has not been attached
correctly.
Nailer is overloaded.
Battery or main unit is overheated.
Power tool abnormalities.
The nailer is recoiling.
The driver blade is worn down.
The anti-blank fi ring mechanism is not
working.
Jammed nails remain around the
discharge outlet.
The driver blade is worn down.
Dirt or other foreign objects have
adhered inside the magazine.
WHY
Blow clean daily.
Blow clean daily.
Recharge the battery with the recharger.
Remove the battery and check to see if foreign
matter exists in the nailer's battery insertion
bed. Also check to make sure that the battery
terminals are not soiled. Press down on the
battery until it clicks into place.
Remove whatever caused the overload.
(Jammed nail, dirt or other foreign objects that
have collected around the blade guide and
driver blade)
Allow the battery and main unit to fully cool
down.
Contact your dealer or the metabo HPT
Authorized Service Center.
There are cases in which hard materials
cannot be nailed correctly.
Press the discharge outlet fi rmly against the
object to be nailed.
Contact your dealer or the metabo HPT
Authorized Service Center.
Contact your dealer or the metabo HPT
Authorized Service Center.
Remove any jammed nails, dirt or other foreign
objects.
Contact your dealer or the metabo HPT
Authorized Service Center.
Remove the dirt or other foreign objects that
have collected in the nail guide groove.
English
HOW
CORRECTION
25