Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
● Choice of triggering method is important.
Please read and understand "METHODS OF
OPERATION" found below.
● Never place your face, hands or feet near
fi ring head when using.
● Do not drive nails on top of other nails or
with Nailer at too steep of an angle; nails can
ricochet and hurt someone.
● Do not drive nails into thin boards or near
corners and edges of workpiece. Nails can be
driven through or away from workpiece and
hit someone.
● Never drive nails from both sides of a wall
at the same time. Nails can be driven into
and through the wall and hit a person on the
opposite side.
● Never use Nailer which is defective or
operating abnormally.
● Do not use Nailer as hammer.
● Do not secure the push lever. Failure to
observe this may result in injury.
● Remove all remaining fasteners and battery
from nailer when:
1) doing maintenance and inspection;
2) checking proper operation of push lever
and trigger;
3) attaching or removing the nose cap;
4) cleaning a jam;
5) it is not in use;
6) leaving work area;
7) moving it to another location; and
8) handing it to another person.
● Remove battery from Nailer when:
1) loading nails;
2) turning the adjuster.
CAUTION
● Use caution not to throw the push lever tip onto
wood when the push lever cannot be pushed up.
NOTE
● Operation may become sluggish if used at low
ambient temperatures. Move to a warm location
and allow the power tool and battery to warm up
before using.
● Do not use the power tool to nail fl ooring or fl oor
materials. Accidentally standing on any nails that
stick up may lead to injury.
● Nails may bend or cracks may appear in the
material depending on the hardness, thickness
or combination of materials. Fire a test nail before
commencing full use.
METHODS OF OPERATION
(1) Disconnecting the battery
Disconnect the battery from the power tool to prevent
unexpected operation.
(2) Loading the nails
Load pin nails of the appropriate size for the job into
the magazine.
(3) Attaching the nose cap
Attach the nose cap as necessary.
(4) Connecting the battery
Push the battery into the power tool until it clicks into
place.
(5) Driving in nails
1 Press the discharge outlet
against the surface
2 Pull the switch
○ Make sure the discharge outlet is fi rmly placed
against the place where the nail is to be discharged
and pull the trigger.
○ If the nails are not driven in completely, press the
head of the power tool down fi rmly when nailing.
○ To adjust the nailing depth, see the section
"ADJUSTING THE NAILING DEPTH".
<Safety Device>
Nails will not be discharged until the push lever
is pressed against the object to be nailed and the
trigger is pulled.
In other words, nails will not be discharged when
only the trigger is pulled, or when only the push lever
is pressed against the object to be nailed. This is to
prevent the nails from being discharged when the
trigger is accidentally pulled or when the push lever is
accidentally placed against something.
(6) Finishing work
When work is fi nished, disconnect the battery and
then remove all the nails.
ANTI BLANK FIRING MECHANISM
This nailer is equipped with an anti blank fi ring mechanism
to prevent blank fi ring when the nails run out.
The trigger will cease to operate when 20 or fewer nails
remain.
Approximately 20 nails will remain after fi ring the strip
of nails, but replenishing the magazine with nails of the
same length will enable nailing to be continued.
English
Head
19
Publicité
Table des Matières
