Stihl TS 480i Notice D'emploi page 38

English
Definitions
1 Rear Handle
Handle for the operator's right hand.
2 Throttle Trigger Lockout
Must be depressed before the
throttle trigger can be activated.
3 Throttle Trigger
Controls the speed of the engine.
4 Stop Switch
Switches the engine's ignition off
and stops the engine.
5 Starter Grip
The grip of the pull cord for starting
the engine.
6 Manual Fuel Pump
Provides additional fuel feed for a
cold start.
7 Fuel Filler Cap
For closing the fuel tank opening.
8 Water Attachment
For connecting the water supply
when wet cutting.
9 Tensioning Nut
For tensioning the ribbed belt.
10 Adjusting Lever
For adjusting the position of the
wheel guard.
11 Abrasive Cutting Wheel
The cutting attachment, either
composite or diamond.
12 Front Thrust Washer
Distributes clamping pressure of
mounting nut evenly over cutting
wheel.
36
13 Wheel Guard
Covers a portion of the wheel,
reducing the risk of injury from
kickback and inadvertent contact by
the operator and captures and re-
directs sparks, cutting debris or
wheel fragments.
14 Muffler
Reduces engine exhaust noises
and diverts exhaust gases away
from operator.
15 Spark Arresting Screen
Designed to reduce the risk of fire
from exhaust sparks.
16 Front Handle
Handle for the left hand.
17 Decompression Valve
Releases compression to make
engine starting easier - when
activated.
18 Spark Plug Boot
Connects the spark plug to the
ignition lead.
19 Water Control Panel
When the engine is running, it is
possible to activate / deactivate the
electronic water control and adjust
the water flow.
20 Cover for Control Unit
Covers and protects the control unit.
21 Filter Cover
Covers and protects the air filter
element.
Clutch (Not illustrated)
Couples engine to the belt pulley
when the engine is accelerated
beyond idle speed.
Belt Pulley (Not illustrated)
The mechanism that drives the
ribbed belt and the abrasive cutting
wheel.
Anti-Vibration System (Not
illustrated)
The anti-vibration system includes a
number of elements designed to
reduce the transmission of vibration
created by the engine and cutting
process to the operator.
TS 480i, TS 500i