Stihl TS 480i Notice D'emploi page 26

English
Removing an abrasive wheel
2
Use the combination wrench to
N
loosen and remove the hexagon
head screw (2)
Remove the front thrust washer (3)
N
from the shaft together with the
abrasive wheel
24
Fitting an abrasive wheel
4
Fit the new abrasive wheel (4)
N
WARNING
Note the arrows indicating the direction
of rotation on diamond abrasive wheels.
Fit the front thrust washer (3). The
N
catches of the front thrust
washer (3) must engage in the shaft
grooves
Screw in the hexagon bolt and
N
tighten it with the combination
wrench – if using a torque wrench,
refer to the "Specifications" for the
tightening torque
Draw the locking pin out of the V-
N
belt guard
WARNING
Never use two abrasive wheels at the
same time. The uneven wear creates a
risk of breaking and an injury hazard!
TS 480i, TS 500i