Raw Sdi Output - Blackmagic Design Blackmagic Studio Cameras Manuel D'installation Et D'utilisation

uint8[1]
bit 0:
bit 1:
bit 2-3:
bit 4:
bit 5:
bit 6-7:
. . .
Master Device
Byte 7 MSB 6
Version Version
0
(0b0) (0b0)
Reserved Reserved
1
(0b0) (0b0)
Reserved Reserved
2
(0b0) (0b0)
3 ...

RAW SDI Output

If you would like to perform your own debayering of the image data from Blackmagic Micro
Studio Camera 4K, you can use the 'RAW' mode to output bayered sensor data over the
SDI output.
This mode packs raw data into the pixels of a regular UltraHD 422 frame size, to enable
transmission through a standard SDI output.
The data can be recorded as an uncompressed QuickTime movie using a disk recorder capable
of uncompressed 10-bit recording.
TIP Camera raw media formats are so named because they capture raw color space
data directly from the sensor. Raw image data cannot be displayed visually, and must
be debayered or demosaiced to convert the original raw data into image data that can
then be used in an image processing pipeline like DaVinci Resolve.
Note that Blackmagic DaVinci Resolve does not support the debayering of raw data
from Blackmagic Micro Studio Camera 4K.
slave device 3 program tally status (0=off, 1=on)
slave device 3 device preview tally status (0=off, 1=on)
reserved (0b00)
slave device 4 program tally status (0=off, 1=on)
slave device 4 preview tally status (0=off, 1=on)
reserved (0b00)
Slave Device
(1)
Slave Device
(2)
Slave Device
(3)
5 4
Version Version
(0b0) (0b0)
Slave 1 Slave 1
Preview Program
Slave 3 Slave 3
Preview Program
Monitor Device
3 2
Reserved Reserved Monitor
(0b0) (0b0) Preview
Reserved Reserved Slave 0
(0b0) (0b0) Preview
Reserved Reserved Slave 2
(0b0) (0b0) Preview
Informazioni per sviluppatori (English)
1 0 LSB
Monitor
Program
Slave 0
Program
Slave 2
Program
546