Technical Data; Support - Franke SMART PLUS SGP 62 M F Serie Manuel D'installation Et Mode D'emploi

EN
Replacing the oven lamp
A
Turn off the power to the appliance by means of
X X
the omnipolar switch used for connecting it to
the electrical system, or disconnect the plug if
accessible.

TECHNICAL DATA

Power supply voltage and frequency
Total power and fuse rating
Power and heating elements
Upper
Lower
Grill
Fan
Tangential fan
Oven lamp

SUPPORT

In the event of any operation problems, contact
a Franke Technical Service Centre (refer to the
attached list).
Never use the services of unauthorised
technicians.
Specify:
– the type of fault;
– the appliance model (Art./Cod.);
– the serial number (S.N.).
SGP 62 M _/F / SMP 62 M _/F / SMP 66 M _/F
Franke ovens are equipped with
a circular lamp positioned in the
top left area at the back of the
compartment. To replace the
oven lamp, proceed as follows:
Unscrew the glass cover (A).
X X
Unscrew the lamp and replace it with one
X X
resistant to high temperatures (300 °C),
with the following characteristics:
– Voltage: 220/240 V ~ 50-60 Hz
– Power: 25 W
– Connection: G9
Refit the glass cover (A) and reconnect
X X
the power supply.
220-240 V, 50/60 Hz
2300 W ~ 16 A
1000 W
1250 W
2250 W
30 W
15 W
1 x 25 W
– 14 –
This information is given on
the appliance dataplate on the
warranty certificate.