Technical Data - Franke CM 65 M Manuel D'installation Et Mode D'emploi

Carefully lift the internal glass (Fig. 3c): the two
X X
blocks will prevent the door from closing (if the
blocks are not turned fully, removing the glass will
cause immediate closing of the door).
To remove the glass in between, slide out the two
X X
side gaskets (Fig. 3d) and then lift out the glass
(Fig. 3e).
After carrying out the cleaning operations, refit
X X
the intermediate glass (Fig. 3f) (the correct
position is indicated by the wording „TEMPERED
GLASS" which must be perfectly legible) by
inserting it carefully into the relevant grooves
located at the top of the door and pushing it all
the way to the end of the groove.
Then replace both gaskets (Fig. 3g), taking
X X
extra care to ensure they are inserted as far as
possible, until they come into contact with the
upper edge of the door.
Finally, refit the internal glass (Fig. 3h) and turn
X X
the two glass retaining blocks back to their
original locking position.
Never try closing the door when only one
or both blocks have partially or completely
freed the internal glass. After cleaning,
always remember to turn both blocks before closing
the door.
Removing the oven door (Fig. 4)
To facilitate oven cleaning, the oven door can be
removed by operating on the hinges as follows:
The hinges are equipped with two moveable locks
X X
(A). Lift the lock (A) to release the hinge.

TECHNICAL DATA

Power supply voltage and frequency
Total power and fuse rating
Power and heating elements
Upper
Lower
Grill
Fan
Tangential fan
Oven lamp
Oven lamp
Then lift the door up and pull it outwards; to do
X X
this, hold the door at the sides near the hinges.
To refit the door, first slide the hinges into their
X X
grooves.
Before closing the door, remember to turn the two
X X
locks (A) used as hinge attachments.
Refer to the pictures at the end of this manual.
Replacing the oven lamp
A
Turn off the power to the appliance by means of
X X
the omnipolar switch used for connecting it to
the electrical system, or disconnect the plug if
accessible.
Unscrew the glass cover (A).
X X
Unscrew the lamp and replace it with one
X X
resistant to high temperatures (300 °C),
with the following characteristics:
– Voltage: 220/240 V ~ 50-60 Hz
– Power: 15 W
– Connection: (E14) small.
For models with _/F
– Power: 25 W
– Connection: G9
Refit the glass cover (A) and reconnect the power
X X
supply.
220-240 V, 50/60 Hz
2300 W ~ 16 A
1000 W
1250 W
2250 W
30 W
15 W
1 x 15 W
1 x 25 W for models with _/F
– 15 –
FRANKE ovens are equipped
with a circular lamp positioned in
the top left area at the back of
the compartment. To replace the
oven lamp, proceed as follows:
EN