Working Techniques - Stihl MS 150 TC Notice D'emploi

English
Pushback (B)
Pushback occurs when the chain on the
top of the bar is suddenly pinched,
caught or encounters a foreign object in
the wood. The reaction of the chain
drives the saw straight back toward the
operator – to avoid this risk:
Be alert to situations that may cause
–
the top of the guide bar to be
pinched
Do not twist the guide bar in the cut.
–
10

Working Techniques

Cutting
Do not operate your saw in the starting
throttle position. Engine speed cannot
be controlled with the throttle trigger in
this position.
B
Work calmly and carefully – in daylight
conditions and only when visibility is
good. Ensure you do not endanger
others – stay alert at all times.
Use the shortest possible guide bar: The
chain, guide bar and chain sprocket
must match each other and your saw.
Position the saw so that your body is
clear of the cutting attachment.
If conditions allow, work from a lift
bucket.
Never work on a ladder or on any other
insecure support, do not work above
shoulder height.
Cordon off the work area in order to
reduce the risk of injuries and damage to
property from falling branches (e.g.
motor vehicles).
When working with a lifeline there is a
risk of cutting through the rope – to
reduce the risk of fall injuries, always
use double lifelines.
Take special care when cutting through
a limb. Hold the machine firmly to control
and counteract the feed force. Note
when reaching the end of a cut that the
saw is no longer supported in the kerf.
You have to take the full weight of the
saw – increased risk of accidents.
MS 150 TC