Commissioning; Safety Instructions; Running - Burkert 8201 Manuel D'utilisation

Commissioning

8. commissioninG
8.1.

safety instructions

Warning
Danger due to non conforming commissioning.
Non conforming commissioning could lead to injuries and damage
the device and its surroundings.
• Before commissioning, make sure that the staff in charge have
read and fully understood the contents of the manual.
• In particular, observe the safety recommendations and intended
use.
• The device/installation must only be commissioned by suitably
trained staff.
Protect this device against electromagnetic interference,
ultraviolet rays and, when installed outdoors, the effects of
the climatic conditions.
8.2. commissioning
→
Plug the right-angle plug on the connector.
→
Tighten the plug nut.
The green LED of the connector lights up if the device is powered
(see Fig. 6).
Type 8201
English
Fig. 6: Position of the LEDs in the connector
8.3.

Running

In normal running:
• the green LED is lit to ensure that the device is powered
• the yellow LED is on as long as electrolyte is in the bottle.
If the yellow LED goes off, see chap. 9.3.
green green LED
yellow
yellow LED
13