Mp3 Output; Background Color Names Changed - Korg Pa2Xpro Mode D'emploi

Calibration
Use this button to calibrate and choose the polarity of the pedal/
footswitch.
1. Connect the pedal or footswitch to the ASSIGN PEDAL/
SW connector on the back of the instrument.
2. Go to this page, and touch the "Calibration" button in the
display. The following dialog box appears:
3. You are asked to set the pedal to the maximum value. Press
the footswitch, or press the pedal to the maximum position
(usually front pressed).
4. Touch the "Push" button in the display to confirm the max-
imum value. The following dialog box appears:
5. You are now asked to set the pedal to the minimum value.
Release the footswitch, or press the pedal to the minimum
position (usually back pressed).
6. Touch the "Push" button in the display to confirm the min-
imum value.
7. Check if the pedal or footswitch is working properly, assign
it a function, then save by choosing the "Write Global-Glo-
bal Setup" command from the page menu.
Note: After loading a new Operating System, an older Global file, a
"SET" folder containing an older Global file, or a Backup file, you
might need to re-calibrate the pedal/footswitch.
KORG Pa2X – Operating System release 2.0
Damper
Gbl
Calibration
Use this button to calibrate the action of the Damper pedal, and
set the polarity of a Damper pedal different than the supplied
one. See above for details about the procedure.

MP3 Output

The MP3 player's output can now be assigned to the sub-outs, as
an alternative to the main outs. This allows for separate mixing if
needed.
Audio Out
See "Audio Setup: Style/Kbd" in the User's Manual for more
information on the available audio outputs.

Background color names changed

Background colors, to be selected in the Global > General Con-
trol > Interface page, are now indicated by numbers, instead of
names.
13
Global Mode
Gbl