Use Of The Tool And Care; Service; Specific Safety Rules - Enarco VET Manuel D'instructions

3.4 USE OF THE TOOL AND CARE

USE clamps or other practical way to secure and support the work piece to a stable platform.
DO NOT FORCE tool.
USE the correct tool for your application.
DO NOT USE tool if switch does not turn it on or off.
DISCONNECT the plug from the power source before making any adjustments, changing
accessories, or storing the tool.
STORE idle tools out of reach of children and other untrained persons.
MAINTAIN tool with care.
CHECK for misalignment or binding of moving parts, breakage of parts, and any other condition that
may affect the tools operation.
If damaged, HAVE the tool serviced before using.
USE only accessories that are recommended by the manufacturer for your model.

3.5 SERVICE

Tool service MUST BE PERFORMED only by qualified repair personnel.
When servicing a tool, USE only identical replacement parts.
FOLLOW instructions in the Maintenance section of this manual.

3.6 SPECIFIC SAFETY RULES

For the proper operation of the vibrator, MAKE SURE that operators have been instructed in the
proper management of this machine.
For the autonomous operation of the vibrator, it MUST BE ENSURE that the operators have been
instructed in the use of this machine.
The vibrator SHOULD ONLY BE USED in the specific jobs for with it the help of this manual.
Before connecting the vibrator to the electrical system, MAKE SURE that the voltage and frequency
coincide with the ones stated in the characteristics equipment plate, located in the top part of the
housing.
ENSURE that all frame screws are tight before starting work and the vibrator is securely attached to
its anchor.
DO NOT OPERATE the vibrator when it is running.
DO NOT WORK with housing broken.
DO NOT WORK CLOSE To flammable liquids or in areas exposed to flammable.
DO NOT ALLOW untrained or inexperienced personnel to operate the vibrator or connections.
KEEP the vibrator in a clean and dry area.
MAKE SURE that the electrical cable is with the proper section and functioning properly (see section
4.5).
BEFORE DOING any type of repair, DISCONNECT the vibrator from the electrical system.
WHEN CONNECTING to a generator, MAKE SURE that the out tension and frequency is stable,
right, and has the proper power. The converter's feeding voltage should not vary more than ± 5% as
stated on the vibrator's plate.
MONO-PHASE AND THREE-PHASE EXTERNAL VIBRATORS
VET VEM
en
5