Always disconnect the appliance from the electricity and gas mains before proceeding
with any servicing operation.
REPLACING HOT PLATE PARTS
Replacement of the components housed inside the appliance: remove the trivets and
the burners from the upper part of the working table; remove the fixing screws "V" of
the burner (fig. 14) and the knobs fixed by pressure with the hans, in order to take off
the appliance.
After having carried out the above listed operations, the burners (fig.15), taps (fig. 16)
and electrical components can all be replaced (fig. 17). It is advisable to change seal "D"
(fig.16) whenever a tap is replaced to ensure a perfect tightness.
Greasing the taps (see fig. 18 - 19)
•
If a tap becomes stiff to operate, it must be immediately greased in
compliance with the following instructions:
•
remove the tap.
•
Clean the cone and its housing using a cloth soaked in diluent.
•
Lightly spread the cone with the relative grease.
•
Fit the cone back in place, operate it several times and then remove it again.
Eliminate any excess grease and check that the gas ducts have not become
clogged.
•
Fit all parts back in place, complying with the demounting order in reverse.
•
Check the tightness by using soapy water. The use of the flame is prohibited.
48