•
No part of the pipe must be able to touch parts the temperature of which
exceeds 65 K.
•
The pipe must not be pulled or twisted, throttled or tughtly bent.
•
It must not come into contact with sharp edges or corners.
•
It must be easy to inspect the entire pipe length in order to check its state of
wear.
•
The pipe must be replaced within the date stamped on the pipe itself.
•
The appliance complies with the provisions of the following CEE Directives: CEE
2009/142 + 93/68 regarding gas safety.
TECHNICAL INFORMATION FOR THE INSTALLER
Installation, adjustments of controls and maintenance must only be carried out
by a qualified engineer.
The appliance must be correctly installed in conformity with current law and the
manufacturer's instructions.
Incorrect installation may cause damage to persons, animals or property for
which the Manufacturer shall not be considered responsible.
During the life of the system, the automatic safety or regulating devices on the
appliance may only be modified by the manufacturer or by his duly authorized
dealer.
INSTALLING THE HOT PLATE
Check that the appliance is in a good condition after having removed the outer
packaging and internal wrappings from around the various loose parts. In case of doubt,
do not use the appliance and contact qualified personnel.
Never leave the packaging materials (cardboard, bags, polystyrene foam, nails, etc.)
within children's reach since they could become potential sources of danger.
39