Silverline RS5322B01 Manuel D'utilisation page 47

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Always disconnect the appliance from the electricity main before making any
adjustments. All seals must be replaced by the technician at the end of any adjustments
or regulations.
TAPS
"Reduced rate" adjustment
Switch on the burner and turn the relative knob to the "Reduced rate" position
(small flame fig. 1).
Remove knob "M" (fig. 12 and 12/A) of the tap, which is simply pressed on to its
rod. The by-pass for minimal rate regulation can be: beside the tap (fig. 12) or
inside the shaft. In any case, to access to regulation, it can be done trought the
insertion of a small screwdriver ''D'' beside the tap (fig. 12) or in the hole ''C''
inside the shaft of the tap (fig 12/A). Turn the throttle screw to the right or left
until the burner flame has been adequately regulated to the "Reduced rate"
position.
The flame should not be too low: the lowest small flame should be continuous and
steady. Re- assemble the several components.
44

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Rs5322c01Rs5322r01

Table des Matières