Installation Instructions - Silverline RS5322B01 Manuel D'utilisation

INSTALLATION INSTRUCTIONS

FIG. 3 FIG. 4 FIG. 5
The installer should note that the appliance that side walls should be no higher than the
hot plate itself. Furthermore, the rear wall, the surfaces surrounding and adjacent to the
appliance must be able to withstand an overtemperature of 65 K.
The adhesive used to stick the plastic laminate to the cabinet must be able to withstand
a temperature of not less than 150 °C otherwise the laminate could come unstuck.
The appliance must be installed in compliance with the provisions in force.
This appliance is not connected to a device able to dispose of the combustion fumes. It
must therefore be connected in compliance with the above mentioned installation
standards. Particular care should be paid to the following provisions governing
ventilation and aeration.
ROOM VENTILATION
It is essential to ensure that the room in which the appliance is installed is permanently
ventilated in order to allow the appliance itself to operate correctly. the necessary
amount of air is that required for regular gas combustion and ventilation of the relative
room, the volume of which must not be less than 20 m3. Air must naturally flow through
permanent openings in the walls of the room in question. These openings must vent the
fumes outdoors and their section must be at least 100 cm2 (see fig. 3). Construction of
36