Silverline RS5322B01 Manuel D'utilisation page 44

•
Detach the seals from their backing, checking that the transparent protection
still adheres to the seal itself.
•
Overturn the hot plate and correctly position seal "E" (fig. 9) under the edge of
the hot plate itself, so that the outer side of the seal perfectly matches the outer
perimetral edge of the hot plate. The ends of the strips must fit together without
overlapping.
•
Evenly and securely fix the seal to the hot plate, pressing into place with the
fingers and remove the strip of protective paper from the seal and set the plate
into the hole made in the cabinet.
•
Fix the hob with the proper brackets "S" and fit the prominent part into the
porthole "H" on the bottom; turn the screw "F" until the bracket "S" stick on the
top (fig. 10).
•
In order to avoid accidental touch with the overheating bottom of the hob,
during the working, is necessary to put a wooden insert, fixed by screws, at a
minimum distance of 70 mm from the top (see fig. 7).
IMPORTANT!
A perfect installation, adjustment or transformation of the cook top to use other gases
requires a QUALIFIED INSTALLER: a failure to follow this rule will void the warranty.
Comply with the Dimensions (mm)
4F
553
ELECTRICAL CONNECTION
IMPORTANT: The appliance must be installed following the manufacturer's instructions.
The manufacturer will not be liable for injury to persons or animals or property damage
caused by an incorrect installation.
A B C
473 63.5
D E
63.5 100 min.
41