Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
02.2000
4
Installing the "SSB" board
♦ Assembly preparations for construction types E to G (H)
The bracket for mounting the SSB is supplied in a semi-assembled state. The metal sheet must be bent to a 90°
angle as shown in the sketch below (Fig. 4.1). The bend line is perforated.
Bend to 90° angle!
Fig. 4-1
Final state of support plate for the SSB board
26
Siemens AG
6SE7080-0AX87-1JB0
Safe Stop Board
Operating Instructions
Publicité
Chapitres
Table des Matières
