Important - Matrix 59695037 Guide De L'utilisateur

Before turning the machine on, make sure
that adjusting keys and wrenches have been
removed.
• Store unused power tools safely. They should
be stored in a dry place, locked or placed up
high so that they are out of reach of children.
• Use the correct power tool.
• Do not use low output machines for heavy
work.
• Do not use the power tool for purposes for
which it was not intended.
• When working outdoors, non-skid footwear
is recommended.
• Take good care of tools. Keep cutting tools
sharp and clean for better and safer working
conditions.
• Regularly check the power tool's power cord
and have it replaced by a certified technician if
damaged.
• Inspect extension cords regularly and replace
them if they are damaged.
• Avoid accidental starting of the machine.
• Make sure that the switch is off when
plugging it into the mains.
• Check the power tool for damage.
• Before further use of the power tool, safety
devices or slightly damaged parts should be
carefully inspected for proper and intended
function.
• Verify that the moving parts work properly
and do not jam and check that there are no
damaged parts. All parts must be installed
correctly and meet all requirements to ensure
the proper operation of the power tool.
• Damaged safety devices or other parts
must be repaired by an authorized dealer
in accordance with regulations or replaced,
unless otherwise specified in the instructions.
6
• Damaged switches must be replaced at a
service station.
• Do not use electric tools with switches that
cannot be turned on and off.

IMPORTANT:

• The use of other service tools and other
accessories can mean a risk of personal injury.
• Your power tool must be repaired by a
qualified electrician.
• This power tool complies with the relevant
safety regulations.
Repairs may only be performed by a qualified
electrician, using original replacement parts,
otherwise injury to the user may occur.
Additional safety notes for mitre saws
• Do not use deformed or damaged blades.
• Do not operate the saw without guards in
place.
• Replace the table insert when worn.
• The saw should only be used to cut wood,
wood-like materials and plastics.
• Use only the manufacturer's recommended
saw blades that meet the EN847-1 standard.
• Attach a dust collector to your mitre saw
during operation.
• Select the blades according to the material to
be cut.
• Check the maximum depth of cut.
• When cutting longer pieces always use
extension rails and insert clamps or other
clamping devices for better grip.
• Wear ear protection.
• The operator must stand in front of the
machine.
• Use the clamping device to secure the
workpiece.