Matrix 59695037 Guide De L'utilisateur page 9

Assembling the Saw Dust Bag
• Press the flaps of the metal ring together
and attach it to the discharge opening in the
engine area.
Appropriate Usage
Intended Usage
The machine cuts:
• Wood and wood-like materials
• Plastic
Inappropriate Usage
The machine is not suitable for:
• Ferrous materials, steel and cast iron, as well
as all other types of materials that are not
listed, especially food.
• Compound cuts without protection.
• Materials which are larger than the indicated
cutting capacities:
0°/0°/ 5 29/32 x 2 23/64 IN (15X6.0 CM)
45°/0° 3 11/32 x 2 23/64 IN (8.5X6.0 CM)
0°/45° 5 29/32 x 1 1/4 IN (15X3.2 CM)
45°/45° 3 11/32 x 1 1/4 IN (8.5X3.2 CM)
Start-up
Observe the safety notes in the operating
instructions before operating the machine.
REMOVAL OF PACKAGING
Remove the box used to protect the machine
during transportation and keep it intact for
future transportation and storage.
DISPLACEMENT
As the mitre saw is relatively small and light, it
can be easily transported even by one person.
It is sufficient to lift the saw by the handle after
the locking button (13) has been locked in the
lowest position.
TRANSPORT
In case the machine needs to be transported
put it in the original packing in which it was
delivered. See to it that it is placed in the
correct position (follow signs on box).
If possible secure the box with straps to avoid
unintended movement or loss of parts of the
machine.
POSITION/WORK STATION
Place the machine on a work bench or on a
sufficiently flat base/pedestal to ensure the
best possible stability.
Bearing in mind ergonomic criteria, the
ideal height of the bench or of the base
should be such that the base surface or the
upper work surface is between 90 and 95 cm.
from the ground.
Always ensure that there is at least 80 cm. of
manoeuvring space in all directions around
the machine in order to perform all necessary
cleaning, maintenance and adjustment
operations safely with a sufficient amount of
space available.
WARNING: Ensure the machine is placed in
a suitable position both in terms of ambient
conditions and lighting. Always bear in
mind that overall ambient conditions are of
fundamental importance to prevent accidents.
ELECTRICAL CONNECTIONS
Check that the electrical system to which
the machine is connected is grounded in
compliance with voltage safety regulations
and that the socket is in perfect condition.
The electrical system must be fitted with a
GFCI device to safeguard all conductors from
short circuits and overload.
The selection of this device should be in line
with the following electrical specifications of
the machine stated on the motor.
NOTE: Your mitre saw's electrical system is
equipped with an undervoltage relay which
automatically opens the circuit when the
voltage falls below a minimum pre-established
limit and which prevents the self-reset of
machine functions when voltage returns to
normal levels.
If the machine stops involuntarily, do not be
alarmed.
9