Replacing The Power Cable; Technical Data; Important; Cleaning And Maintenance - Matrix MS 800 Traduction De La Notice Originale

7.3 Electronic speed control (B4)
By increasing pressing the on / off switch (1), the
speed increases.
With the speed selection (4) in the ON / OFF
switch (1), the desired speed can be selected.
Turn toward +: higher speed
Turn towards -: lower speed
8. Operation
8.1 ON/OFF switch (B5)
To switch on:
Press the ON/OFF switch (1)
To switch off:
Release the ON/OFF switch (1)
8.2 Locking button (B5)
You can lock the ON/OFF switch (1) using the
locking button (2) when the equipment is in
operation. To lock it, press the ON/OFF switch. To
switch off the equipment briefly hold down the
ON/OFF switch.
8.3 Use as a jigsaw (B6)
Place the multi-saw on the material to be cut as
shown in Fig. 6. Switch on the multi-saw and
push it along against the material to be cut.
Adapt your cutting speed to the material.

9. Replacing the power cable

If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
aftersales service or similarly trained personnel to
avoid danger.

10. Technical data

Mains voltage:
Power input:
Stroke speed:
Cutting depth, wood:
22
230-240 V~ / 50 Hz
800 W
-1
0 – 2800 min
105 mm
Cutting depth, iron:
Protection class:
Weight:
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level 90 dB(A)
pA
K uncertainty 3 dB(A)
pA
L sound power level 101 dB(A)
WA
K uncertainty 3 dB (A)
WA
Wear ear-muffs.
The impact of noise can cause damage to
hearing.
Total vibration values (vector sum of three
directions) determined in accordance with EN
60745.
Cutting sheet metal
a : Main handle: 12.23m / s
h,M
Front handle: 11.17m / s
K uncertainty = 1,5 m/s

Important!

The vibration value changes according to the
area of application of the electric tool and
may exceed the specified value in exceptional
circumstances.

11. Cleaning and maintenance

Always pull out the mains power plug before
starting any cleaning work.
11.1 Cleaning
• Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
• We recommend that you clean the device
immediately each time you have finished using it.
• Clean the equipment regularly with a moist
cloth and some soft soap. Do not use cleaning
2
2
2
5 mm
II /
2.4 kg