Proper Use - Matrix 59695037 Guide De L'utilisateur

• Turn off the power tool if the blade gets
stuck in the workpiece or the workpiece gets
wedged.
• Warning: Do not use blades made of high
speed steel.
• Keep the floor area free of loose particles
such as wood chips and cutoffs.
• Make sure that the blade speed indicated on
its label is at least as high as that of the saw
speed.
• Use gloves when handling saw blades and
rough materials.
• Be sure to use only shims and spindle rings
that are suitable for the purpose specified by
the manufacturer.
• Warning: Do not remove cuttings or other
parts of the work piece from the cutting area
while the machine is running and the saw has
not yet come to a complete stop.
• Always clamp the work piece to the saw
table.
• Make sure that the machine is sitting securely
before beginning to saw.
WARNING! Noise can be harmful to your
health. If a sound level of 85dB (A) is exceeded,
ear protection must be worn.
Before each use, all guards and other parts
should be carefully inspected to see whether
they still fulfill their functions.
Check for alignment, smooth operation,
breakage or other damage that could impair
function. A damaged part should either be
immediately and professionally repaired or
replaced.
Hazard from blocking work pieces or parts!
If blockage occurs, please proceed as follows:
1. Switch the device off
2. Unplug it
3. Wear gloves
4. Clear blockage with appropriate tools.
Layout
Parts list refers to figures on pages 2 and 3.
1 Grip
2 Start switch
3 Base
4 Joint for casing / base
5 Rotary table
6 Motor
7 Saw blade
8 Table insert
9 Saw blade guard, fixed
10 Saw blade guard, moveable
11 Chip bag
12 Clamping jaw
13 Locking button

Proper Use

• The machine must only be used in technically
perfect condition in accordance with its
designated use and the instructions set out in
the operating manual, and
only by safety-conscious persons who are fully
aware of the risks involved in operating the
machine. Any functional disorders, especially
those affecting the safety of
the machine, should therefore be rectified
immediately.
• Any other use is unauthorized. The
manufacturer is not responsible for any
damages resulting from unauthorized
use; risk is the sole responsibility of the
operator.
• The safety, work and maintenance
instructions of the manufacturer as well as the
technical data given in the calibrations and
dimensions must be adhered to.
• Relevant accident prevention regulations and
other, generally recognized safety- technical
rules must also be adhered to.
7