Remaining Hazards - Matrix 59695037 Guide De L'utilisateur

• The machine may only be used, maintained,
and operated by persons familiar with it and
instructed in its operation and procedures.
Arbitrary alterations to the machine release
the manufacturer from all responsibility for
any resulting damages.
• The machine may only be used with
original accessories and tools made by the
manufacturer.

Remaining Hazards

The machine has been built using modern
technology in accordance with recognized
safety rules. Some remaining hazards,
however, may still exist.
• Only process selected woods without
defects such as: Branch knots, edge cracks,
surface cracks. Wood with such defects is
prone to splintering and can be hazardous.
• Wood which is not correctly glued can
explode when being processed due to
centrifugal force.
• Trim work piece to a rectangular shape,
center and correctly secure before processing.
Unbalanced work pieces can be hazardous.
• Long hair and loose clothing can be
hazardous when the work piece is rotating.
Wear personal protective gear such as a hair
net and tight fitting work clothes.
• Saw dust and wood chips can be hazardous.
Wear personal protective gear such as safety
goggles and a dust mask.
• The use of incorrect or damaged mains cables
can lead to injuries caused by electricity.
• Even when all safety measures are taken,
some remaining hazards which are not yet
evident may still be present.
8
• Remaining hazards can be minimized
by following the instructions in "Safety
Precautions", "Proper Use" and in the entire
operating manual.
• Do not force the machine unnecessarily:
excessive cutting pressure may lead to rapid
deterioration of the blade and a decrease in
performance in terms of finish and cutting
precision.
• When cutting aluminum and plastics always
use the appropriate clamps: all work pieces
must be clamped down firmly.
• Avoid accidental starts: do not press the
start button while inserting the plug into the
socket.
• Always use the tools recommended in this
manual to obtain the best results from your
mitre saw.
• Always keep hands away from the work
area when the machine is running; before
performing tasks of any kind release the main
switch button located on the handgrip, thus
disconnecting the machine.
Assembly
WARNING! For your own safety, only insert
the mains plug in a socket after you have
completed all assembly steps, and read
and understood the safety and operating
instructions.
Take the saw out of its packing and position it
on the work bench.
Remove the saw from the packaging and place
it on a workbench.