Matrix 59695037 Guide De L'utilisateur page 13

Troubleshooting
Problem Possible Cause
The motor does not Faulty motor, power supply cable or
run. plug.
Burned out fuses.
The motor starts Low-power supply voltage.
slowly and does not Damaged windings. Burned out
reach running speed. capacitor.
Excessive motor noise. Damaged windings. Faulty motor.
The motor does not Overloaded circuit due to lighting,
reach full power. utilities or other motors.
Motor overheats Overload of the motor; inadequate
easily cooling of the motor.
Decrease in cutting The saw blade is too small
power when (sharpened too often).
The saw cut is rough The saw blade is dull; the tooth
or wavy. shape is not suited to the thickness
of the material.
The work piece rips or The cutting pressure is excessive or
splinters. the saw blade is not suited to the
application.
Help
Have the machine checked by
skilled personnel. Do not try to
repair the machine yourselves as it
may be dangerous. Check the
fuses and replace them if necessary.
Ask the Electricity Distributor
to check the voltage available.
Have the machine motor checked
by skilled personnel. Have the
capacitor replaced by skilled
personnel.
Have the motor checked by skilled
personnel.
Do not use other utilities or motors
on the circuit to which the cutting-
off machine is connected.
Prevent overloading the motor
when cutting; remove dust from
the motor to ensure an optimum
cooling of the motor.
Re-adjust the end stop of the saw
unit.
Re-sharpen the saw blade or use an
appropriate saw blade.
Use the correct saw blade.
13