Electrical Connection - Matrix 59695037 Guide De L'utilisateur

Make sure that there has not been a voltage
failure in the electrical system.
Adjusting
ATTENTION: All the adjustment procedures
illustrated below must be performed when
the machine's engine is off.
Cross-cutting Operation: Swiveling the
Table Top (Fig. 2)
By turning the table, the mitre saw can be
moved to the left- and right- hand side. Using
the scale, an exact angle setting is possible.
15°, 22,5°, 30°, angles
from 0° to 45° can be quickly and precisely
set. For swinging the turning table, release
the locking screw (a) and turn the unit at the
handle (1) until the desired angle is obtained.
Then secure with locking screw (a).
Tilting the Saw Unit (Fig. 3)
The saw unit can be tilted up to an angle of
45º.
Loosen the hand grip (b) on the back of the
machine and, using the scale, tilt the unit to
the desired angular position.
The angle can be determined using the
indicator (c) on the scale (a). Finally, the hand
grip must be securely re-tightened.
Operations
After having performed all the above
procedures and operations, you may begin
cutting.
Warning: Always keep hands away from the
cutting area and do not try to approach it
when the machine is running.
Cross-cutting Operation (Fig. 4)
• Release the locking button (13)
• Raise the saw unit using the hand grip
(1) until the unit locks into the uppermost
position.
10
• Press the work piece uniformly against the
block bars (a), while ensuring that your hand is
outside the cutting zone of the saw blade.
• With the right hand on the hand grip (b), so
that the unit can be swiveled downward.
• After pressing of the start button (2) the
engine starts running.
• Apply the saw blade slowly to the work piece
and cut through it by applying slight pressure.
• Swing the unit back into the starting position
until it locks into place.
• Release the hand grip (1), so that the motor
shuts off.
Changing the Saw Blade (Fig. 5)
• Pull the power plug.
• Put the sawing unit in the upper position.
• Release the movable saw blade guard (10)
and lifting the saw blade guard at the same
time to free the saw blade.
• Release the saw blade fixing screw (Attention:
left-handed thread).
• Remove bolt (a) and saw blade flange (b).
• Take off the saw blade with caution (risk of
injury through saw blade teeth).
• Place the new saw blade onto the inner saw
blade flange, observing the turning direction
of the saw blade.
• Put the outer saw blade flange in place and
firmly tighten the screw.
• Return the saw blade guard to the correct
position.

Electrical Connection

The mitre saw's electric motor is completely
wired ready for operation. The customer's
connection to the power supply system,
and any extension cables that may be used,
must comply with local regulations.
Important:
The motor is automatically switched off in
the event of an overload. The motor can be
switched on again after a cooling down period
that can vary.