Regular Maintenance; Disposal Of The Machine - Matrix 59695037 Guide De L'utilisateur

Warning: Noise can seriously damage your
health. If the engine noise exceeds 85 dB (A),
please wear appropriate hearing protection. If
the electrical connection is faulty, the voltage
may drop when the machine starts. This may
affect other machines (e.g. flashing lights).
If the electric output corresponds to Zmax
<0.27, such interference should not occur. (If it
does, notify your dealer).
• The vibration emission value given below has
been measured by a standardized test, and
can be used for comparing one power tool to
another;
• The vibration emission value given below
may also be used for a first assessment of
exposure.
Warning:
• The vibration emission value may vary during
actual use of the power tool from the specified
value, depending on the manner in which the
power tool is used;
• Try to keep exposure to vibration to a
minimum. Examples of ways to reduce
vibration levels are wearing gloves when
using the tool and limiting working hours. In
doing so, all parts of the operating cycle must
be taken into account (for example, times in
which the power tool is turned off, or when it
is turned on without load).
Maintenance
If service personnel must be brought in
for exceptional service or repairs during
the warranty period and thereafter, please
contact a service provider recommended
by us or contact the manufacturer directly.
• Overhauls, maintenance work,
cleaning, as well as the elimination of any
malfunctions must only be undertaken after
turning off the motor.
• All protective and safety equipment must be
12
reinstalled immediately upon completion of
any repair or maintenance work.

REGULAR MAINTENANCE

The regular maintenance described above and
in the paragraph below can be carried out by
unskilled personnel.
• Do not oil the mitre saw because cutting
must be always be carried out in dry
conditions (including the cutting of aluminum
and aluminum alloys); all rotating parts are
self-lubricating.
• During maintenance, wear protective gear
if possible (accident-prevention goggles and
gloves).
• Remove cuttings when necessary both from
the cutting area, work surfaces and support
bases.
Use of a vacuum cleaner or brush is
recommended.
WARNING: Do not use compressed air jets!
• Regularly check blade conditions: if
difficulties should arise during cutting, have it
sharpened by skilled personnel or replace it if
necessary.
ASSISTANCE
When in need of skilled personnel for special
maintenance, or for repairs, both during and
following the guarantee period, always apply
to authorized centres for assistance or directly
to the manufacturer if there is no authorized
centre in your area.

DISPOSAL OF THE MACHINE

Once its operating life is finished, the disposal
of the machine must take place through a
standard Collection and Disposal Centre for
industrial waste.