Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
turning off the motor.
• All protective and safety equipment must
be reinstalled immediately upon completion
of any repair or maintenance work.
REGULAR MAINTENANCE
The regular maintenance described above
and in the paragraph below can be carried
out by unskilled personnel.
• Do not oil the mitre saw because
cutting must be always be carried out
in dry conditions (including the cutting
of aluminum and aluminum alloys); all
rotating parts are self-lubricating.
• During maintenance, wear protective gear
if possible (accident-prevention goggles
and gloves).
• Remove cuttings when necessary both
from the cutting area, work surfaces and
support bases.
Use of a vacuum cleaner or brush is
recommended.
WARNING: Do not use compressed air
jets!
• Regularly check blade conditions: if
difficulties should arise during cutting, have
it sharpened by skilled personnel or replace
it if necessary.
ASSISTANCE
When in need of skilled personnel for
special maintenance, or for repairs, both
during and following the guarantee period,
always apply to authorized centres for
assistance or directly to the manufacturer if
there is no authorized centre in your area.
Disposal of the machine
Once its operating activity is finished, the
disposal of the machine must take place
through a standard Collection and Disposal
Centre for industrial waste.
Please contact your municipality for
available services in your area.
12
Publicité
Table des Matières
