Basic Configuration Of Dome Camera System - Eneo MPP-72A0020MIA Guide D'installation Rapide

CAUTION: Before installing mounting bracket to surface pre-adjust the four
mounting screws "A" on the base of the dome camera to best match the mounting brack-
et locked position. Unscrew the locking screw on the side of the dome's base and fit the
tab of the mounting bracket into the locking slot. Screws "A" should not be too tight or
too loose when the dome is in the locked position. After setting the proper positions of
screws "A" remove the mounting bracket and install it to the proper surface. If it is too dif-
ficult to lock the dome in position after the mounting bracket has been installed readjust
the screws "A" by unscrewing them a small amount and try to install dome camera again.

Basic Configuration of Dome Camera System

No. Type
1 DC JACK
2-PIN
2
TERMINAL BLOCK
3-PIN
3
TERMINAL BLOCK
3-PIN
4
TERMINAL BLOCK
3-PIN
5
TERMINAL BLOCK
6 BNC BLACK
7 BNC YELLOW
8
Description
CAMERA POWER (12VDC)
TX+: RS485+ (A)
TX-: RS485- (B)
A1: ALARM INPUT 1
A2: ALARM INPUT 2
G: GND
A3: ALARM INPUT 3
A4: ALARM INPUT 4
G: GND
AO1: ALARM OUTPUT 1
AO2: ALARM OUTPUT 2
G: GND
HD OUTPUT
CVBS OUTPUT