Program Execution; Checking The Workpiece During A Running Program; Moving To The Service Position - Amann Girrbach ceramill motion 2 Mode D'emploi

A P P L I C A T I O N A N D O P E R A T I O N
6.6

Program Execution

Before executing a program, it must first be
E N
loaded (see Ceramill Match 2 software).
▷ Briefly press operation button [A].
The program is started. Operation button [A]
lights up.
The program can be stopped:
▷ Briefly press operation button [A] or service
button [B].
-or-
▷ Open the door.
The program is stopped. Operation button [A]
flashes.
To continue the program:
▷ With the door closed, briefly press operation
button [A].
The program is continued at the position where
it was stopped. Operation button [A] lights up.
On completion of the program, the machine
returns to the starting position. Operation button
[A] goes out.
72
6.7 Checking the Workpiece During a
Running Program
▷ Press operation button [A] for at least three
seconds.
The program is stopped. The spindle returns to
the rear, the current tool is placed down and the
workpiece is turned around. While travelling,
operation button [A] is lit; after reaching the
position, it flashes.
▷ Visually check the workpiece.
▷ Briefly press operation button [A].
The tool is picked up again. The spindle travels
to the position, where the program was inter-
rupted. While travelling, operation button [A] is
lit; after reaching the position, it flashes.
▷ Briefly press operation button [A].
The program is continued. Operation button [A]
lights up.
6.8

Moving to the Service Position

The service position can be moved to from the
starting position or from a stopped program.
▷ Briefly press service button [B].
The current tool is placed down and the spindle
returns to the service position. The spindle is
released; the motor is blocked. While travelling,
operation button [A] is lit; after reaching the
position, it flashes.
To exit the service position:
▷ Briefly press operation button [A].
The tool is picked up again. The spindle travels
back to the starting position or to the position,
where the program was interrupted. While trav-
elling, operation button [A] is lit; after reaching
the position, it flashes.