ESAB PT-31XL Manuel D'instruction page 78

sEctIoN 4 MaINtENaNcE
CRIMP OR SOLDER
WHITE LEADS
SWITCH END PLUG
COVER
sWItch KIt p/N 0558005509
figure 4-2. switch Disassembly
To replace - Remove switch band from torch (see figure 4-1). Pull the switch and end plug out of the cover. Snip the white
leads from the switch (leads supplied with the torch cable bundle are sufficiently long to allow cutting). Crimp or solder
the replacement switch to the leads.
Note:
Switch can be mounted on top or bottom
of handle.
figure 4-3. switch placement
To reposition the switch on the torch, slide the flex support back, remove the tape securing the leads to the power cable,
reposition switch, retape the leads, and pull the flex support back in place (see note below). See Figure 4-1.
Note
A thin film of silicone lubricant P/N 0558000443, supplied with the spare parts kit, applied inside
of the flex support will ease the assembly of this part.
78