Bluetooth Mode; Nfc (Near Field Communication) - TechniSat DIGITRADIO 225 Mode D'emploi

Bluetooth Mode

Pair the unit with a Bluetooth device to listen to music:
1. Press the MODE button to select Bluetooth mode.
The display will show 'Bluetooth discoverable...'.
2.
3. Activate your Bluetooth device and select the search mode.
4. 'DigitRadio 225' will appear on your Bluetooth device.
5. Select 'DigitRadio 225' and enter "0000" for the password if necessary.
6. 'BT connected: Your Bluetooth Device' will show on the display when connection is
successful.
7. While a track is playing, you can:
a. Press button once to resume to the beginning of track, and then press
once again to skip to previous track; press and hold
playing track.
b. Press /PRESET button to pause or play current playing track.
c. Press button to skip to next track; press and hold
playing track.
8. To disconnect current Bluetooth connection, press and hold PAIR button for 2 seconds.
9. To connect to another paired Bluetooth device, press PAIR button repeatedly to select the
Bluetooth device you desired, and then press SCROLL&SELECT/SNOOZE knob to confirm
connecting.
@
Note: the unit will automatically switch to standby mode after 10 minutes if the source device
is disconnect, switched off or the volume is too close to mute.

NFC (Near Field Communication)

NFC enables you pair and connect with Bluetooth devices in an easy way.
1. Press MODE button repeatedly to select Bluetooth mode.
2. Make sure that your NFC is turned "On" on your mobile device.
3. Hold your mobile device about 2cm close to NFC sensor at right side panel for receiving an
auto-connection between your mobile device and radio.
4. Your device then will turn-on Bluetooth automatically and will pair your device with radio. No
additional settings are necessary.
button to fast reverse current
button to fast forward current
button