When switching on for the first time, the frequency 87.5 MHz is set.
If you have already set or saved a station, the radio plays the last station set.
In the case of RDS stations, the station name appears.
Adjust the antenna to improve reception.
12.2 FM reception with RDS information
RDS is a procedure for broadcasting additional information via FM stations.
Broadcasters with RDS might, for example, broadcast their station name or the
programme type. This is shown in the display.
>
The device can show the following RDS information:
RT (Radio text),
PS (Station name),
PTY (Programme type).
12.3 Manual station selection
>
Press or in FM mode to set the desired station. The display shows the
frequency in steps of 0.05 MHz.
12.4 Automatic station selection
>
Press SCAN to start the automatic scan. The station frequency runs upwards
in the display.
or
>
In FM mode, hold down or for approx. 2 seconds to automatically
search for the next station with a strong enough signal.
If an FM station with sufficient signal intensity is found, the scan stops and
the
station is played. If an RDS station is being received, the station name
appears and, possibly, radio text.
Please use manual station selection for setting weaker stations.
Under Menu > Scan settings you can set whether the scan only finds strong
stations (Strong stations only). To do so press the MENU button and > Scan
settings > [Yes]. Confirm the selection with OK.
12.5 Setting mono/stereo
>
Press the MENU button and use or to select > Audio setting.
64