Electrical Connection; Wall Mounting - Sonnenkonig VIDRO 1000 Mode D'emploi

6 Electrical Connection

The following points should be checked before connecting the heater to the power:
EN
•
Does the mains voltage match the voltage of the device?
•
Are the socket and the mains supply sufficiently fused?
•
If a cable reel is used, is it completely unwound?
•
Is the appliance plug suitable for the building socket?
•
Is the socket outlet used equipped with proper earthing?
•
The unit should not be lower than the power outlet.
•
To avoid danger, a damaged connection cable may only be used by the manufacturer, his
customer service or a qualified person.

7 Wall Mounting

7.1 Before attempting the wall mount
Refer to the table for the dimensions required for wall mounting. Also make sure that the required
minimum distances are observed. Only use screws that support the weight of the device and are made
for the corresponding wall. Also check that there is a power outlet in the immediate vicinity to connect
the device.
Device
VIDRO 1000
VIDRO 2000
L1
L
Power
(W)
500/1000
1000/2000
48
48
H1
L
H
[mm] [mm] [mm]
515 450 218 344
835 450 538 344
H
L1 H1
[mm]