3 Electrical connection
The following points should be checked before the electrical connection of the heater:
- Does the mains voltage match the voltage of the unit?
- Are the socket and the supply network adequately protected?
- If a cable reel is used, is it fully unwound?
- Is the appliance plug suitable for the building socket?
- Is the used socket equipped with a faultless grounding?
4 Description of parts
1 Thermostat
2 Sequence switch
3 Cable holder
4 Castors
5 Ribs
6 Control light
7 Handle
5 How to use
5.1 Commissioning
To install the heater, proceed as follows:
- Turn the heater upside down.
- Position the wheelbase between the end ribs.
- Attach the wheelbases to the heater using the supplied U-bores and wing nuts.
7
6
1
2
3
4
31
GB
5