Antari WiFi-800 Mode D'emploi page 5

1. One unit of Antari WiFi-800 Fog Machine
2. Power cord
3. User Manual
If any equipment is missing contact your ANTARI dealer immediately.
Before beginning your initial setup on ANTARI WiFi-800 Fog Machine, make sure that there
is no evident damage caused by transportation. In the event that the unit's housing or cable
is damaged, do not plug it in and do not attempt to use it until after contacting your ANTARI
dealer for assistance.
 Setting Up
Step 1: Place the machine on a flat surface and in a suitably large area with at least 50 cm
of open space around the machine.
Step 2: Fill the fluid tank with Antari approved fluid.
Step 3: Connect the machine to suitably rated power supply. To determine the power
requirement for the machine refer to the label on the back of the machine.
Step 4: Turn on the machine and allow it to heat up, while the machine is heating up the
LED status light on pushbutton will "Flash Red". Heat up takes approximately 2 minutes.
Once the machine has reached operating temperature, the status LED will light "Solid Red".
Now the machine is ready for operation.
Step 5: To start making smoke, press the pushbutton located on the handle; release
pushbutton to stop.
Step 6: To turn off the machine, put the power switch to the OFF position.
 App Download for iOS/Android
Downloading the application
Login to the App Store (iOS) or Google Play (Android), download the Antari WIFI800
application. It allows you to control the WiFi-800 using your mobile devices with iOS /
Android operating systems.
5