Key And Panel Description - Adam Equipment SHS Serie Mode D'emploi

EN
2.4 KEY AND PANEL
[ON/OFF]
[Zero]
[Unit]
[Hold]
© Adam Equipment Company 2012
DESCRIPTION
The power switch is located on the rear housing. Use this key to
turn the scale ON and OFF.
Press the [Zero] key to return the reading to zero.
Press the [Unit] key to change the weighing unit being displayed
between Kg, Lbs and Newtons (Newtons not available for "a"
models)
Use this key to activate standard Hold. When pressed the Hold
LED will light at the top left side of the display and the reading on
the display will lock and flash. Press the [Hold] key again to
cancel the [Hold] function.
*When Peak hold is selected from the parameter section the
press of the Hold key will activate Peak Hold. The Hold LED will
flash and the display will also flash and lock showing the
maximum weight registered of a single weighing process.
Press the [Hold] key again to cancel the [Hold] function.
5 7.00.6.6.0202, Revision B November 2012