Specification; Battery Replacement - Amprobe BT-120 Mode D'emploi

SPECIFICATIONS
Operating & Detection
Voltage for Transmitter
Operating Frequency
Storage Temperature
Operating Temperature
Sensitivity Adjustment
Power Supply
Transmitter Polarity
Humidity
Environmental
Conditions
Caution

BATTERY REPLACEMENT

Power is supplied by one 9 V alkaline battery (Receiver).
The Identification Arrow LED on the Receiver will not turn ON when
replacement is needed. To replace the battery, remove the screw from the back
of the meter and slide the battery door outward. Remove the battery from
case bottom and replace it with a fresh 9 V alkaline battery.
BT-120
90-120 VAC,
Not to exceed ±10%
(inclusive in rating)
50 Hz to 60 Hz
32 °F to 104 °F (0 °C to 40 °C)
32 °F to 104 °F (0 °C to 40 °C)
Automatic
9 V alkaline battery (Receiver)
Automatic
50% RH (non condensing)
Indoor use, altitudes up to 2000 m,
Pollution Degree 1 or 2, Installation Category II
BT-VLA cord assembly to be used with Transmitter
only according to instructions.
6
BT-250
90-250 VAC,
Not to exceed ±10%
(inclusive in rating)
40 Hz to 70 Hz
Slide battery
door outward
Remove screw