Safety Information; Environment Conditions; Maintenance & Cleaning; General Specification - Amprobe AMB-45 Manuel De L'utilisateur

Masquer les pouces Voir aussi pour AMB-45:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1.800.544.2843

SAFETY INFORMATION

Read the following safety information carefully before attempting to operate or service the meter.
The circuit under test must be de-energized and isolated before connections are made except for voltage
measurement.
Circuit connections must not be touched during a test.
After insulation test, capacitance circuits must be allowed to discharge before disconnecting the test leads.
To avoid damages to the instrument do not apply the signals, which exceed the maximum limits shown in
the technical specification tables, to the meter.
Do not use the meter or test leads if they look damaged. Use extreme caution when working around bare
conductors or bus bars.
Use the meter only as specified in this manual; otherwise, the protection provided by the meter may be
impaired.
Caution when working with voltages above 60V DC or 30 V AC RMS. Such voltages pose a shock hazard.
Before taking resistance measurements or testing acoustic continuity, disconnect circuit from main power
supply and all loads from the circuit.

Environment Conditions

Installation Categories III 600V, Categories II-1000V
Pollution Degree 2
Altitude up to 2000 meters
Indoor use only
Relatively humidity 80% max.
Operation Temperature 0 ~ 40
Maintenance & Cleaning
Only qualified personnel should perform repairs or servicing not covered in this manual.
Periodically wipe the case with a dry cloth. Do not use abrasives or solvents on these instruments.

GENERAL SPECIFICATION

Display: 70 x 46mm Big LCD Panel with 60 segments analog bar Indication.
Over range Indication: "OL" will be shown on the LCD Panel when out of range measurement is made,
except for insulation resistance test, where the "HI" will be shown.
Low Battery Indication: The will be show when the battery need to be changed.
Sampling Rate: 2.5 times/sec Digital Display; 10 times/sec Bar Graph
Power Source: 1.5V AA size Battery X 8
Operating Temperature and Humidity: 0
Storage Temperature: -10
to 60
Dimension: 230 x 116 x 62 mm (9 x 4.6 x 2.4 inch)
Weight (with battery): Approx. 750g (1.65 lb.)
Accessories: Test Lead, Large Jaw Alligator Clips, Battery, Carrying Case, Software, RS-232 Cable, Users
Manual.
www.calcert.com
15
10
20
5
25
0
30
to 40
(32
to 104 ), below 80% RH
(14
to 140 )
4
sales@calcert.com

Publicité

Table des Matières
loading

Table des Matières