Operation - Amprobe BT-120 Mode D'emploi

OPERATION

Breaker and Fuse Identification
1. Plug the Transmitter into an energized wall outlet (Figure 1).
2. Make sure the red LED is ON to indicate that the outlet is energized.
3. Push the Power switch on the Receiver to turn it ON. The Receiver will
beep and the Power LED will be lit.
4. At the breaker panel or fuse box, hold the Receiver perpendicular to the
breakers. Scan slowly all breakers once to calibrate the Receiver. During
this scan, the Receiver may beep and flash at several breakers. This is a
normal part of the identification process (Figure 2).
5. Without touching the ON/OFF button, begin scanning again to identify
the right breaker or fuse. When the Receiver beeps, the correct breaker
has been identified.
6. Push and hold the Power switch for three seconds to turn the Receiver
off. Beeping and flashing during the shutdown is normal.
7. Unplug the Transmitter from the wall outlet.
Figure 1
Figure 2
4