Maintenance And Servicing; Replacing The Laminar Flow Control - Franke AQUALINE AQLT0085 Notice De Montage Et De Mise En Service

15. Maintenance and Servicing

Depending on the quality of the water, the local conditions and the rules and regula-
tions applicable on site, the fitting must be maintained and serviced at regular
intervals.
Perform maintenance on the following components:
• Filters (see
• Non-return valve (see
• Functional part (see
Properly use suitable cleaning agents that are not harmful to the fittings and rinse
with water after use. High-pressure cleaners must not be used for cleaning.
Removing the Fitting
Some maintenance work requires the fitting to be removed.
15.1 Use an Allen key to close the water volume regulator (see
15.2 Trigger the fitting.
15.3 Loosen the union nut (b).
15.4 Remove the fitting.

16. Replacing the Laminar Flow Control

16.1 Use an open-end spanner to unscrew and replace the laminar flow control (a).
16.2 Replace the laminar flow control.
Chapter 17.)
Chapter
Chapter 20.)
19.)
Chapter 10.14).
9