GYS GYSPOT PTI GENIUS Manuel D'utilisation page 44

INSTALLATION – PRODUCT OPERATION
Only qualified personnel authorised by the manufacturer should perform the installation of the welding equipment. During the installation, the
operator must ensure that the machine is disconnected from the mains. Connecting generators in serial or in parallel is forbidden.
EQUIPMENT DESCRIPTION (FIG-1)
This machine is designed to carry out the car body repair operations described below :
- spot welding on sheets using a pneumatic clamp,
- welding of sheets using a gun,
- welding of nails, rivets, washers, studs, mouldings,
- repair of bumps and impacts (hail impacts with the pliers option).
1- SD card reader
2- Interface (MMI)
3- Cooling unit
4- Overhanging arm locking support
5- Regulator
DESCRIPTION OF THE G CLAMP (FIG-2)
1- Arm locking/unlocking lever
2- Interchangeable arm
3- Gyroscope
4- Pneumatic body
5- Over-opening electrode
6- Side handle
Clamp opening : push the button (FIG 2 - 10), the opening of the clamp can be released. The electrode retracts in the clamp leaving a space of
80 mm to access the welding area instead of 20 mm when not in use.
ACCESSORIES AND OPTIONS
Coolant
5 l: 062511
10 l: 052246
Caps sharpener
048966
100
180
96
G1 (550 daN) - ref. 022768 INCLUDED
44
GYSPOT PTI GENIUS
40 caps
x 18
x 10
048935
Pressure sensor Welding test case
052314
100
93
G2 (300 daN) - ref. 022775
6- Power-on circuit breaker
7- Power cord
8- Filling cap
9- Cooling liquid gauge
7- Locking latch
8- Gyro lock/unlock mechanism
9- Over-opening button
10- Spot welding button
11- Remote settings button
12- Stem height control lever
Protective cover
x 18
x 6
050068
Europax
anti-corrosion
050433 052758
180
205
154
96
G3 (550 daN) - ref. 022782
SD card including automatic
programs INCLUDED
050853
Kit renove
Kit gun PTI GENIUS
wifi
070691
G2 + G3 + G4 - ref. 022898
EN
050914
067226