Audio; Display - Volkswagen Zubehör Touch Phone-Kit Music Mode D'emploi

000 051 473 C BA Touch Phone-Kit Music.book Seite 89 Freitag, 24. Februar 2012 8:04 20
89
User training:
The hands-free device's voice control works regardless of who the speaker is and this means that the
voice control system will normally be functioning without the driver's agreement. User training is needed
in certain cases, e.g. if you have a very strong dialect, in order to ensure that the voice control functions
work correctly. During the user training process the hands-free device will say twenty terms which must
be repeated out loud.
Description:
A brief introduction to the hands-free device's voice control system.

9.3 Audio

Ringing tone:
You can use the Mobile setting to import your mobile telephone's ringing tone into the hands-free device.
The hands-free device also has eight ringing tones of its own. The selected ringing tone and the mobile
telephone's ringing tone will be replayed through the vehicle's speakers if a call comes in. Use the Next
or Previous voice command to page through the list.
Volume:
Menu for setting the basic volume for voice instructions, ringing tone and audio playback for the hands-
free device. The volume can be adjusted using the loudspeaker controller on the radio during the
playback. The following voice commands can be used within the menu Louder, Quieter, Maximum and
Minimum. Say Select to confirm the setting.
Audio delay:
Use the and buttons to set a delay time between 0.0 - 3.0 seconds for the hands-free device's
voice.
Mobile telephone audio:
If Mobile telephone audio is activated, audio playback from the mobile telephone, such as
announcements during mobile navigation, is given via the vehicle loudspeakers.
Note
If the function Mobile telephone audio is active, all audio playback will only be in mono!
●

9.4 Display

Sleep mode:
Sleep mode can be activated for the screen to avoid blinding effects, e.g. whilst driving at night. The
screen will be turned off in compliance with the setting if sleep mode is switched on. The screen can be
reactivated by touching it or automatically by an incoming call.
Brightness:
The brightness of the screen can be changed via the brightness menu. The following voice commands
can be used within the menu More, Less, Maximum and Minimum. Say Select to confirm the setting.
Day / night modes:
The touchscreen display can be switched manually for the use by day or by night. This setting is
controlled automatically by the integrated sensor inside the operating console in automatic mode.
Automatic mode is activated in the factory.
Calibration:
After the hands-free device has been in use for a long time, the touchscreen might need to be recalibrated
under certain circumstances, e.g., if the touchscreen commands are no longer implemented correctly. A
cross appears on the touchscreen after you have started the calibration . Touch the cross as
accurately as possible and repeat the procedure until calibration has been completed.